Why does my remote starter drain my battery?

Whether your vehicle is loaded with aftermarket tech or runs bone-stock, every electrical system in your vehicle draws power from your battery. Even while your engine is off, a remote start system still draws current while it waits to receive a command from your remote fob.

Can a faulty remote start drain your battery?

If your car did not come with a remote starter and you want to install an aftermarket model, improper installation could lead to issues with your battery and electrical systems. “Factory installed starters should not be a problem,” said Lauren Fix of CarCoachReports.com.

Can remote start cause problems?

Remote starters increase engine wear and tear. This is a common misconception about remote starters. It’s unclear why people are lead to believe this is the case, but it’s untrue. The consensus among mechanics is that remote starters are good for your engine, especially for people with turbos or diesel engines.

Is my car starter draining my battery?

The starter will draw a charge from the battery. If it’s drawing too much, that’s a clear indicator that’s has failed. The vehicle may still start; however, it will continue to draw too much power and will drain the battery.

How many times can you remote start your car?

After remotely starting the engine, how long will the engine run before it shuts off? Any vehicle started with the remote engine starter can idle for a total of 20 minutes. Automatic engine shutdown occurs after 10 minutes, but the vehicle may be remotely started as many times as you wish for an additional 10 minutes.

Can remote start damage alternator?

The Damage Myth There is a myth that remote starters can damage your vehicle. The truth of this is, a properly installed, high quality system will not cause any damage.

Can a remote starter drain a car battery?

Parasitic current drain can be defined as any electrical device that draws electric current when the ignition key is turned off. In the case of a remote starter, the radio receiver must be powered so that it can receive the starter signal.

How to reset a Python remote car starter?

Turn the key to the “On” ignition position. Press and hold the “Unlock” button on the fob for one to two seconds, and release it. Hold down the “F” button until the fob’s indicator light glows red, and release it. Press and hold the “Unlock” button for approximately two seconds, or until the indicator light begins to flash, then release it.

How to reset the Python remote start FOB?

Python’s remote start system allows users to operate their power locks and start their vehicle with the simple push of a button. Sometimes, after the battery in the car or remote start fob has been changed, the fob won’t work until it has been reset. Sit in the driver’s seat and close all of the doors. Insert your key into the ignition.