How do you complete a drive cycle on a Nissan?

How do you complete a drive cycle on a Nissan?

Begin driving. Accelerate smoothly to 56 mph with the transmission in Drive (standard power mode and transmission in auto mode) then release gas pedal and coast for 10 seconds. D. Accelerate again to 56 mph and maintain speed for at least 10 minutes.

What is drive cycles for the obd2?

The purpose of the drive cycle is to run your vehicle’s onboard diagnostics. This, in turn, allows monitors to operate and detect potential malfunctions of your vehicle’s emission system. The correct drive cycle for your vehicle can vary greatly, depending on the vehicle model and the monitors that need to be reset.

What is the drive cycle for a 2011 Nissan Altima?

Accelerate to 25 mph in 10 seconds and hold gas pedal steady for 20 seconds. Use smooth and quick acceleration and maintain speed as constant as possible. G. Repeat steps E and F eight (8) times.

How long is an OBD drive cycle?

Preparation for it will take eight hours but, all in all, a basic drive cycle test should take around 30 minutes to complete, with about 20 minutes of actual driving. Understanding your vehicle’s overall health can help you ensure it drives smooth and lasts long.

How far do you have to drive to reset computer?

So why is the light still on? Here’s something you probably don’t know: after clearing the car’s computer you will need to drive for about 50 to 100 miles. As you drive your car the computer will monitor all the sensors and register the results.

What is a drive cycle for emissions?

a drive cycle is one of the methods used by a vehicle’s powertrain control module (pcm) to determine whether an emissions system repair was performed successfully. it involves a special test drive that duplicates the scenario of a person starting the car and making a short freeway trip, as if driving to work.

How do you know when obd2 is ready?

To determine if readiness OBD II monitors are complete:

1. Turn the ignition key to the “on” position for 15 seconds without cranking the engine.
2. If the “Service Engine Soon” light blinks eight times, one or more readiness monitors are incomplete.

What is considered a drive cycle?

How long does it take for an OBDII driving cycle?

A complete driving cycle should perform diagnostics on all systems. A complete driving cycle can be done in under fifteen minutes. To perform an OBDII Driving cycle do the following: Cold Start.

Why is my OBD not ready for a drive cycle?

THIS LED TO THE OBD RESETTING ALL OF ITS STORED LEARNED MEMORY OF THE EMMISSIONS SYSTEM. SO WHEN IT CAME TIME TO COMMUNICATE THE STATE OF MY SYSTEM TO THE MVD, IT WAS “NOT READY”. I WAS TOLD THAT THE OBD NEEDED TIME TO RELEARN THE SYSTEM, AND,THAT A PERIOD OF TIME DRIVING, OR A DRIVE CYCLE, WAS NEEDED TO DO SO.

When to use the OBD-II emission control system?

The OBD-II system is designed to check the emission control system during normal driving. A complete check may take several days. If the vehicle is not ready for E-Check testing, the following driving cycle consisting of mixed city and highway driving should be performed: 15 minutes of steady driving on an expressway/highway followed by

How much does a Nissan Drive cycle cost?

ONE DEALERSHIP SAID THAT BECAUSE IT WAS A “LENGTHY PROCESS”, THAT I COULD ALWAYS COME IN, AND THAT FOR $250, A TECH COULD RUN THROUGH THE DRIVE CYCLE IN A FEW HOURS TIME FOR ME! SO MUCH FOR THAT. I AM STILL UNSURE EXACTLY WHAT MY DRIVE CYCLE IS.