Can you fix reallocated sectors count?
The only “fix” for a reallocated sector is to purchase a new hard drive. Once a sector has been reallocated the hard drive will no longer use it and will continue operation without storing data on that part of the disk. There is no software or hardware fix to lower your reallocated sector count.
Can SSD have bad sectors?
With a traditional hard drive bad sectors can forecast a failure, but due to the nature of flash technology it’s normal to have a small number of bad sectors on an SSD. The easiest way to keep track of the number of bad sectors on an SSD is to run ChkDsk (short for “check disk”) in Windows®.
What’s the reallocated sector count on a SSD?
When I installed the drive and booted up my Linux box, I was greeted to find that Gnome Disk Utility reported that the “disk has many bad sectors” and that the drive is failing. It appears that the reallocated sector count value is at a astonishing 1536 sectors. Do you think this is an acceptable amount for a brand new SSD?
Is there a way to reduce the reallocated sector count?
However, there is no way to reduce the reallocated sectors on your hard drive. You can keep using the hard drive, but don’t keep important data stored on the drive. For users who suspect that their hard drive is going to fail, they can also check the value of the Reallocated Sector Count by themselves.
What does it mean when your hard drive has more than one reallocated sector?
If S.M.A.R.T data for your hard drive is showing a number other than 0 next to “ ID 05 Reallocated Sector Count ”, I’m going to be up front and let you know that this isn’t a good sign. Increases in reallocated sectors are one of the tell tale signs of a drive that’s dying – do not ignore the warnings.
How to fix reallocated sector count warning in Windows 10?
Once you have recovered or backed up the data safely, run following CHKDSK command on the drive to try repair and fix drive errors. Open Command Prompt in administrator mode and then type, CHKDSK /r /f X: (where X is the drive volume letter). Press the ‘ Enter ’ key