Why does my pool have two drains?
When constructing a new swimming pool, if you are going to use a main drain it is required that you use two. This is due to safety regulations to help prevent Main Trap Entrapment. Main drain entrapment occurs when the suction is so great through a single main drain that a person can become stuck on or in the drain.
What is a split drain?
Splitting a Pool Drain for Safety This means that the drain pipe is T’d off to two drain covers instead of a single drain. With a split spa drain, either two drains are installed on the floor of the spa if there is room to place the drains at least 3′ apart or one is placed on the floor and the other one on the wall.
Does a pool have to have a main drain?
Main drains are not required in an inground swimming pool, however, they are strongly recommended and can be extremely useful in some circumstances. This is useful when replacing your pool liner. Main drains are also helpful in the filtering of water and dirt from the bottom of the pool.
What are the two drains at the bottom of my pool?
During normal operation, water flows to the filtering system through two or more main drains at the bottom of the pool and multiple skimmer drains around the top of the pool. The main drains are usually located on the lowest point in the pool, so the entire pool surface slants toward them.
How do you know if your pool is leaking main?
So, if you see that you pressure quickly drops to 2 psi, it’s likely that there’s a leak in the main drain line somewhere between 4′ – 5′ under the water level of the pool. If there is a leak in the section of the line at or above the water level of the pool, you’ll see a quick drop to 0 psi.
Does a mini split drain need a trap?
Every mini split I have done is an evaporator hung on a wall in the room with no duct work or “cabin”. The drain runs inside the unit to an open to atmosphere pan and should not need a trap unless piped and tied into a open plumbing line.
How pool main drain works?
A pool’s so-called main drain is not actually a drain; that is, it is not used to drain the pool. Instead, it is an outlet, housing a pipe that runs to the pump, which sucks water through a skimmer, then through a filter, then through a heater (if you have one), and then back to the pool via multiple inlets.
Should your main drain be open or closed?
For proper water circulation, it is best to position the flap so that it is about 2/3 closed. This will allow for more flow through the main drain than through the skimmer, which will promote a “bottom-to-top” circulation throughout the pool.
Where is the main drain in a swimming pool?
The main drain in your swimming pool is very easy to locate – it sits right at the bottom of the pool. But locating them isn’t actually the problem with swimming pool main drains. The problem is that they can be very dangerous pieces of equipment in the pool, and that many pool owners don’t realize it.
What can I plug in the bottom of my Pool Drain?
Locate the small hole at the bottom of the main drain. This is the plumbing line to the filter. Plug the small hole with an expandable rubber plug or a plastic threaded plug, if the hole is threaded. Replace the main drain lid if needed. Justin A. Mann has been a freelance writer since 2007.
How big of a drain do you need for a swimming pool?
New residential swimming pool code requires two main drains to be installed into the pool bottom, at least 5′ apart, and to also have these dome-shaped covers over their main drains. There’s very little maintenance involved in a main drain of a swimming pool other than cleaning it and the cover.
What should I use to clean the main drain in my swimming pool?
Cleaning the swimming pool main drain is important so that it doesn’t become clogged and so that it can continue to perform its job properly. There is also a pressurized clog remover that you can use on the main drain in your swimming pool to unclog any debris from the main drain with a highly pressurized blast of air.