How do I load a Citrix StoreFront server balance?
- Log onto the Citrix ADC appliance management GUI.
- Select Traffic Management > Load Balancing > Servers > Add and add each of the four StoreFront nodes to be load balanced.
- Use IP-based server configuration and enter the server IP address for each StoreFront node.
How do I load my StoreFront balance?
Load Balancing Virtual Server
- Create or install a certificate that will be used by the StoreFront SSL Load Balancing Virtual Server.
- On the left, under Traffic Management > Load Balancing, click Virtual Servers.
- On the right, click Add.
- Name it lbvip-StoreFront-SSL or similar.
- Change the Protocol to SSL.
Is Citrix NetScaler a load balancer?
Introduction to Citrix NetScaler Load Balancer In large, Unified Intelligence Center deployments, the Citrix NetScaler 1000v (Load Balancer) is used to load balance Unified Intelligence Center HTTP and HTTPS traffic.
How does NetScaler Load Balancing Work?
In a basic load balancing setup, clients send their requests to the IP address of a virtual server configured on the Citrix ADC appliance. The virtual server distributes them to the load-balanced application servers according to a preset pattern, called the load balancing algorithm.
What operating system does Citrix NetScaler use?
Netscaler joined the Citrix family of products by way of an acquisition in June of 2005. It is a customized kernel that resides within the user region of the FreeBSD operating system. FreeBSD is a free open-source operating system with similarities to Unix.
What is Citrix Load Balancing?
Load balancing is defined as the methodical and efficient distribution of network or application traffic across multiple servers in a server farm. Each load balancer sits between client devices and backend servers, receiving and then distributing incoming requests to any available server capable of fulfilling them.
How does load balancing work in Citrix?
What is least connection load balancing?
Least Connection load balancing is a dynamic load balancing algorithm where client requests are distributed to the application server with the least number of active connections at the time the client request is received.
How does Netscaler load balance with Citrix Receiver?
The article provides details of how to configure a NetScaler appliance to load balance incoming requests from Citrix Receiver/Citrix Receiver for Web between all of the StoreFront nodes in the server group and how to configure the new Storefront Monitor for use with a NetScaler or third party load balancer.
How to enable storefront load balancing in Citrix?
If you will use SSL/TLS/https to communicate with the StoreFront servers, in the Basic Parameters section, check the box next to Secure. If you wish to enable the Check Backend Services checkbox, then see Citrix Service Monitor at Citrix Docs for the service that must be installed on the StoreFront Servers.
How to force scriptable monitor to use Snip in NetScaler 10.5?
Note: This is a Perl monitor, which uses the NSIP as the source IP. You can use RNAT to override this as described in CTX217712 How to Force scriptable monitor to use SNIP in Netscaler in 10.5. On the left, expand Traffic Management, expand Load Balancing, and click Monitors. On the right, click Add. Name it StoreFront or similar.
Where to change DNS for storefront load balancing?
The DNS name for StoreFront load balancing must be different than the DNS name for NetScaler Gateway. Unless you are following the Single FQDN procedure. In the Citrix StoreFront console, right-click Server Group and click Change Base URL. Enter the new Base URL in https://storefront.corp.com format.